1/2" SHORT Lag Screw Expansion Shield, 25 pieces per box,SIMLSES50S

MSRP: $45.00
$22.00 per box of 25 pieces
Simpson Strong-Tie Anchors
Manufacturer: Simpson Strong-Tie Anchors
Manufacturer Part No: LSES50S


Die cast Zamac 3 Alloy.


See below.

Tension Load  Normal Weight Concrete
LSES Product Data and Tension Loads
in Normal-Weight Concrete
LSES Product Data and Tension Loads in Concrete
  1. The allowable loads listed are based on a safety factor of 4.0.
  2. The minimum concrete thickness is 1 1/2 times the embedment depth.
  3. Screw is not included.



cautionCaution: Oversized holes may make it impossible to set the anchor and will reduce the anchor's load capacity.

  • Drill a hole in the base material using the appropriate-diameter carbide drill bit as specified in the table. Drill the hole to the specified embedment depth plus 1/8" for flush mounting and blow it clean using compressed air. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling. Overhead installations need not be blown clean.
  • Insert anchor into hole. Tap with hammer until flush with surface of base material.
  • Position fixture; insert screw and tighten.
Installation Sequence
install sequence

Product Reviews

(0 Ratings, 0 Reviews)